Products
Electric Spray Booth Heater
Turns a non-heated booth into a faster waterborne drying booth. Built in any size.
How it works
The blower recirculates cabin air through the heating element and back into the booth, raising temperature about 50°F. Shorter flash-off, very low running cost.
Cost per cycle
$1.80 – $2.10
30 kW unit at $0.12 per kWh.
What's included
- Intake filter
- Ducting and duct insulation
- 2 HP blower
- Pulsing mechanism with pneumatic actuators
- 2 Slim Towers (intake end)
- 2 Original Towers with pneumatic doors (exhaust end)
- Purge timer
- Control panel with all NFPA 86 interlocks
- Exhaust motor VFD (supplied by dealer/installer)
/ Specifications
- Purpose
- Adds heat to non-heated booths. Not a gas air makeup replacement.
- Temperature rise
- About 50°F
- Standard heater
- 30 kW
- Control panel
- UL 508A listed, certified by ETL
Codes & standards
Built for inspection day
- NFPA 33 / IFC Ch. 24: spray application
- NFPA 86 / IFC Ch. 30: curing and drying
- Full-system ETL listings for easier permits and inspections
Requirements vary by location. Confirm with your local AHJ.
FAQ
Electric heaters
When is electric the right choice?
When there's no gas service, emissions rules are strict, or you just want clean heat. You need enough electrical capacity.
Does it help waterborne paint dry faster?
Yes. A 50°F rise shortens flash-off and offsets the slowdown from humidity.
What maintenance does it need?
Filter changes and periodic checks. No burner means less service than gas.
Made in the USA · Factory direct
Add heat to your non-heated booth
Send your booth size and electrical service. We'll size and quote it.